Adel BCR Manual de usuario descargar pdf (Pagina 9)

ADEL S.r.l. – BCR Barcode / Contactless reader - User Manual Rev. 1.3

pag. 9

1 FLASH Command in execution

2 FLASHES Command not executed for title not present in the module

3 FLASHES Command not executed for title already present in the module

4 FLASHES Command not executed for reading already enabled

5 FLASHES Position error

7 FLASHES Title jammed

8 FLASHES Configuration not valid

PROGRAMMING PROCEDURE

For FW download, after setting dip 4-5-6 follow these instructions:

a. Connect serial cable to connector FLASHPRG (JST 4 P.M. a 90°).

b. Keep RESET button pressed and, at the same time, move the dipswitch 6 to On position; verify that

the DL4 led is on and release RESET button.

c. Execute the FUJITSU FLASH MCU Programmer program.

• Select in the Target Microcontroller field the MB90F497/G model.

• Select in the Cristal Fquency field the value of 4MHz.

• Open the file with MHX extension.

• Select the COM port to which the serial cable is connected.

• The screen appears as the one on the button if the COM1 port is used.

• Press the “Full Operation(D+E+B+P)” button.

• When the Flash window appears press “OK”.

• Wait for procedure to finish.

d. At the end of the procedure press OK and close the program.

e. Select in the Target Microcontroller field the MB90F497/G model.

f. Press reset button and at the same time move the dipswitch 6 in Off position and verify that the LED

DL4 switches off. Release the reset button.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

Adel BCR Manual de usuario Pagina 9